1.1.2 - Enter in the PEDDS Data
Step Description:
Click Yes on the box asking to run the PEDDS Project ID application now.


FDOT Project Created Successfully Image


The Financial Tab should be complete based on the information entered in the last step.


PEDDS Financial Tab Image


Note: During this process DO NOT select the Save Changes option until all the tabs have been populated as this will exit the program and you will need to start the project creation process again to get your additional information included for sheet field population.

In the Location Tab enter in the:
  • Project Designation
  • County
  • Roadway ID or Section/Sub ID
  • Begin and End Mile
Then click Add.
Enter in the State Road Number and click Add.


PEDDS Location Tab Image


In the Disciplines Tab, toggle on the appropriate disciplines.


PEDDS Disciplines Tab Image


If there are bridges, go to the Bridge Identification Tab.
Input the following information for each bridge:
  • Bridge Number
  • Surface On Bridge
  • Surface Under Bridge
Click Add after inputting the data for each bridge.


PEDDS Bridge Identification Tab Image


In the Description Tab the information will already be pulled from the data entered earlier.


PEDDS Description Tab Image


Finally, in the Management Tab, enter in the:
  • Manager Name
  • Name of Professional
  • Area of Responsibility
Click Add.


PEDDS Management Tab Image


Click Save Changes to update the Sheet Set Template.
Click OK and this will launch Civil 3D, enter in the necessary information in the sheet set template, and close Civil 3D.

For more information watch the video below
  • Create Project (WMV)